Incident Prevention Magazine

Rob D. Adams, CLCP, CUSP

Scenario-Based Fall Protection Solutions

Web-IMG_0149

At least once in their career, nearly every safety worker in the utility business has been – or will be – faced with the need to use fall protection in an area where there is no place to tie off. In my role as a safety technician, I work with personnel in both generation and transmission business units; fall protection is needed in this line of work, but I have found that anchorage points can sometimes be few and far between. It’s a problem that clearly needs to be solved, and in this article I will share what my company has done to provide scenario-based solutions.

Scenario One
During an outage preparation meeting a couple of years ago, I was presented with some fall protection issues that employees had been dealing with. These issues specifically related to anchorage points for crews working on our main steam stop valves. Once the grating and I-beams were removed from the valve pit area, all potential anchorage points were eliminated, and thus no fall protection could be properly anchored and used in the valve pit area. Given this problem, I contacted a fall protection solutions group that came to visit our facility and gathered information regarding our anchorage concerns. While the solutions group was on-site, we also discussed possible recommendations to solve the anchorage problem. In a follow-up email after our initial meeting, the solutions group provided detailed information about the different types of equipment we could use to eliminate our anchorage issues on this particular project. The detailed equipment recommendations were then presented to our company’s personnel, and ultimately the decision was made to purchase the recommended equipment.

That recommended equipment was two advanced portable fall arrest posts, which allow us to provide overhead tie-off and utilize small self-retracting lifelines, or SRLs, so that workers in the valve pit are equipped with complete fall protection. Among the advantages of the portable fall arrest posts is how the posts are mounted. They offer several mounting applications that range from weld-on plates to beam clamps that are designed to fit 6-inch to 14-inch I-beams, meaning that we can use the posts in numerous locations throughout the company. Time and time again, the equipment has proven to be the solution to many of our fall protection needs in both generation and transmission work, including in Scenario Two below.   

Continue reading
  1354 Hits
  0 Comments

KNOWLEDGE, INSIGHT & STRATEGY FOR UTILITY SAFETY & OPS PROFESSIONALS

Incident Prevention is produced by Utility Business Media, Inc.

360 Memorial Drive, Suite 10, Crystal Lake, IL 60014 | 815.459.1796 | This email address is being protected from spambots. You need JavaScript enabled to view it.
© 2004 - 2018 Incident Prevention. All Rights Reserved.